Reply to thread

So as some of you may remember I started a scratch build rotj fett. This got put on hold due to various things. Now 3d printing is at a standard that I'm happy with I'm going to continue with the build. The real question is do I go back and build a 3d printed helmet or stick with my fibre glass one I built and what are the pros/cons over fiberglass or printed lids?

Any help would be massively appreciated. Thanks. :)


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top