Reply to thread

I'm sure you'll be happy with the Devcon Plastic Welder as it lives up to it's name. Just make sure that everything is lined up the way you want it because once the rapidly hardening epoxy sets, it's not coming off. It's worked great thus far on all of my projects but I have trouble working with the fast hardening rate of the epoxy, which is about 5 to 15 minutes, as I don't have the best dexterity in my right hand anymore. Good luck with your snaps!


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top