Reply to thread

Also be sure that there is no paint on the plastic surfaces you are joining. I use Devcon Plastic Welder. They usually have it at Walmart.


First be sure that the pieces line up properly to your body.


For mine, I installed snaps to the armor pieces, and then I put a little paint on the ends of each one and pressed it against the vest on my body. It leaves drill spots for the snaps on the vest.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top