Reply to thread

Task series is a better product. OOMOO is too easy to tear and is not very rigid, mold life is very limited.


That CRC mold release is nasty nasty stuff, I used it once when I was out of the good stuff, I would stay away at all costs.


I only recommend using MANN ease release 200 aerosol or 205 liquid. Smooth on site or below.


Buy Ease Release® 200 & 205 General Purpose Release Agent from Reynolds Advanced Materials


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top