Reply to thread

Hi DeathProof.


I am using an unit designed for the RC car world. It runs off 7.4v power and 100% pure vegetable glycerin ( same as used in ECigs ).

Its all self contained and I've run two Silicone hoses that run through the exhaust nozzles.

The switch is wired through the gauntlet hose, to the momentary push to make non latching toggle switch in the gauntlet. I connect it via a locking DIN plug flush mounted next to the other greeblies in the base of the jetpack.

I've also got a push to make switch wired into one of the belt boxes.


The unit runs off two 2.5ml squirts into each port where the hoses attach. Since the below pics were taken I've secured two plastic nozzles into the unit to make attaching / detaching the hoses easier.


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top