Reply to thread

Asok bought the fettpride moulds. The only diference is that Asok is doing them with cold casted polyurethane resin while fettpride used to do them with gelcoat/fiberglass/polystyrene resin. But the helmets (as well as the moulds) are exactly the same.


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top