Reply to thread

I tried making a  sticker from my PC and inkjet printer and sticker paper, but with the shape of the bell and the paint, the sticker would not hold. :-(


I ended up using the MB emblem that was sent with the shoulder bells. I figure once I weather it up it will look fine. (Even if it is tad small.


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top