Reply to thread

I might just go down to Home Depot and buy a piece of metal.  They sell these pieces that are something like 36" long x 6" wide x 1/8" or 1/4" thick.  That would be fine for everything but the jet pack tool, and what I'm using for the jet pack tool currently is a machined aluminum rod with knurled places on it...   :)


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top