Reply to thread

Getting the servo to fit right into the stack might be tricky on a TF helmet. Because of the kind of bolt and hollow stalk you might have to dremel out a half circle in the ear and attach the servo arm to the stalk through that.


The hyperdyne circuit board turns the lights on when its in the down position.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top