Reply to thread

I really wish I could, but unfortunately I've covered the wire connections with hot glue so they would NOT break off or short out.  So I can't use that for reference now.:cry  If somebody has the Hyperdyne remote-controlled servo, all I would need is a picture of both sides of the chip that is inside the remote casing.  If I've got that, then I can show ya how I rigged it to my gauntlet.;)


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top