Reply to thread

Tim thanks for the pics that helps alot.   I have one other question about the resin process. How do you get the resin in the mold and have it cover the upper parts of the mold? Do you you just dump it in and then turn the mold side ways?


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top