Reply to thread

no - not stupid at all.  But you might have to consider doing it in sections which may require you to cut apart the helmet into sections. You can do the modifications to the helmet in bondo or what not before cutting it apart in order to retain accuracy and proportions. These sections can be modified and set up as tools then vaced over.  the vaced pieces then can be assembled to creat your newer helmet.  Hope that makes it a bit more clear...


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top