Reply to thread

Message

I so agree with you on making things from scratch it is such a feeling of gratification to see it all come together.

My wife's first staff was entirely PVC tubing & fittings that was based off of the Hasbro & Sideshow 12" figures, which has now been replaced by a 3D printed one. There are only about 3 maybe 4 very poor screen grabs of the staff. There are some good photos of the tip but the lower section is left up to interpretation.

I look forward to seeing your interpretation of this come together.

[QUOTE="toolguy301, post: 413546"] I so agree with you on making things from scratch it is such a feeling of gratification to see it all come together. My wife's first staff was entirely PVC tubing & fittings that was based off of the Hasbro & Sideshow 12" figures, which has now been replaced by a 3D printed one. There are only about 3 maybe 4 very poor screen grabs of the staff. There are some good photos of the tip but the lower section is left up to interpretation. I look forward to seeing your interpretation of this come together. [/QUOTE]

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification