Reply to thread

YOU KNOW WHAT I USE TO FILL BIG GAPS? POLIESTIRENE......THE HARD ONE..............I JUST CUT A PIECE SMALLER THAN THE HOLE, AND GLUED IT WITH SUPER GLUE....AND I SCULP ON IT.......SO I USE LESS PUTTY............IF YOU SEE IN MY JP, ALL THE PIECES ARE MADE IN POLIESTERENE AS BASE, AND THEN I SCULP A FINE SKIN OF PUTTI ON IT...................


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top