Reply to thread

I am fairly new to pepakura. The stock printed out great and assembled perfect! I fiberglassed the inside of the two halves, but dispite having a good mix ratio, the resin never fully cured and ended in failure..

When it gets warm again, another attempt may be made...... As u may know, it is very hard to be fully satisfyed with a "complete build". :)


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top