Reply to thread

I am working on my Jet Pack Harness Scratch Build. I bent an aluminum tube to the proper "sissy bar" shape. i have black seat belt webbing and; although, they are a little narrow, I have 2" X 1/2" rectangular "split rings" on the way. The only thing I am stuck on, it the larger 2" X 2" square (angled) split rings on the sides at the bottom where the belt and shoulder straps connect to.


Has any one come across a found part that will pass for those parts?


Or a source for the correct size of the other "split rings"?


Ora source the rivets on the grey straps?


Those strap connector/ring parts seem to have countless names.


Thanks


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top