Reply to thread

I use Testors dull coat on my paint jobs primarily to seal the pastel powders I use during weathering. But after its dry I rub the helmet down lightly with one of those green Scotchbrite pads. That brings it up just a touch from dead flat.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top