Reply to thread

My Rubies Bucket....


I used an 1/8" piece of flat steel stock to hold the flair.  The top is not too bad, so i did not mess with shaping the top.  I have a bobamaker T-visor, I have custom cut vinyl decals, and the paint job was a layered technique with the color scheme posted in this forum utilizing the mustard technique (also mentioned in this forum).  I have a hard hat liner epoxyed in side and 2 mini computer fans wired to one switch.






This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top