Reply to thread

Hello everyone! I've had a servo kit for a while now from salamander king and found this link and it is very helpful. Especially the installing part. Here are my two questions, I have a resign stalk from my helmet kit from animefan. Would it be okay you think to drill and tap it with the 8/32 set screw? And where can I get the motherboard case fasteners? I have searched and mostly find a hardware set which had way to many if they are the right ones picture in this tutorial. Or, what would be an alternative method to install the servo, so it could be removable. I know most say just hot glue it in but I want to be able to pull it out if need be. Thanks so much for all your info!


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top