Reply to thread

I have it all built up but I have a question about soldering the switches to the control pads and in the pictures all of the soldering is under the glue.


I'm pretty sure I did it correct (in concept) but the buttons didn't end up working. I just want to see if I'm just terrible at soldering or if I'm terrible at reading directions.


It is one switch per pad right? Like red button for top pad and black button for bottom pad? Or is it like a half and half thing?  I'm as electronically inclined as a koala bear and I just want to make sure I'm doing it right.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top