Reply to thread

Hey Timmer,


My RF is from bobamaker and can be made to light up but the clear lens is solid. Do you think I may have a problem? I have not wired it up yet as I need to figure out the power i need to light 3 LEDs. Also i will put all the electronics in the helmet.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top