Reply to thread

Message

This is the origional configuration when I actually had a working view screen on the inside, so don't mind the stuff in the middle. The RF controller board and server are on the left side ear area. I try hard to keep everything in one spot so it's easier to work on if it needs repair. This was also pre-padding, so there is some open space in there...but not so much anymore. I did end up taking out the viewscreen because the viewing area was so small that it just felt dangerous...but it was pretty cool to have day/night vision inside the bucket at the time.

[QUOTE="NovallTalon, post: 176936, member: 1786"] [IMG]http://mercs.firespray.net/downloadables/mand%27alor%20Helmet/DSCF0578.jpg[/IMG] This is the origional configuration when I actually had a working view screen on the inside, so don't mind the stuff in the middle. The RF controller board and server are on the left side ear area. I try hard to keep everything in one spot so it's easier to work on if it needs repair. This was also pre-padding, so there is some open space in there...but not so much anymore. I did end up taking out the viewscreen because the viewing area was so small that it just felt dangerous...but it was pretty cool to have day/night vision inside the bucket at the time. [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification