Reply to thread

The board is showing the capability for a remote pot, so it will probably handle a remote switch also.  Just run the switch to your gaunt and the wire to your helmet.


I'll have to dig for some nice pics of my current helmet set-up.  They are pretty far down the page lists on the Mercs boards from early early in the year.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top