Reply to thread

That’s precisely how the original seems to have been installed. The upper half of the circuit board covers half of the keyholes, while the remaining keyholes are covered by a piece of plastic (likely the same material as the visor). The lower half of the circuit board stays attached to the calculator pad.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top