Reply to thread

Hey gang,  I'm hoping to use the stencils and trace them onto my armor pieces with carbon transfer paper... My question is, is there a guide or size method to get the scale of the damgages scaled to the armor or is it just trial and error?  I'm great in photoshop and I figured I could just bring the templates in and chop what I need and print them but just trying to find the best way to do it.. Any insight here would be great,   Thanks!


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top