Reply to thread

Message

Sanded with 400 and then 1000 grit, and then applied white primer.... and now drying.

Used a foam block to anchor the ear due to the bolts on the other side. The bolts helped in that the ear remained above the foam block which aided in the application of the primer on the sides/edges. I can see a couple of small holes in the resin that I will fill with some putty.

Second Picture, I have lined up all the paint required and a reminder of instructions and layering. A bottle of masking fluid that needs to be shaken not stirred.
[ATTACH=full]205509[/ATTACH][ATTACH=full]205510[/ATTACH]

[QUOTE="Jimbo, post: 508909, member: 13711"] Sanded with 400 and then 1000 grit, and then applied white primer.... and now drying. Used a foam block to anchor the ear due to the bolts on the other side. The bolts helped in that the ear remained above the foam block which aided in the application of the primer on the sides/edges. I can see a couple of small holes in the resin that I will fill with some putty. Second Picture, I have lined up all the paint required and a reminder of instructions and layering. A bottle of masking fluid that needs to be shaken not stirred. [ATTACH type="full"]205509[/ATTACH][ATTACH type="full"]205510[/ATTACH] [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification