Reply to thread

I would agree that the mandibles are a little too orange. I always use the floquil color but as that is hard to find, Model Master's British Crimson or Tamiya XF-9 Hull Red might do the trick. If you can get both in enamel (yes Tamiya does do enamel) then you could also experiment mixing the two. Your other colors look pretty good!


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top