Reply to thread

Hi all,

I’m a novice here when it comes to painting an ROTJ and using this site so please forgive me if this ends up in the wrong place.


My Dilemma is the original is just too big for my body (head to body ratio)

So I turned to STL 3D print file [ATTACH=full]242469[/ATTACH]but I could only find one the FPH3.

I needed to reduce the size to 96% and the stencils here to 94%.

Which made it very difficult to copy the details.


And I unfortunately missed the Lark grey layer which is terribly annoying as I thought that it came out pretty well.


Well I think so.

Any tips on the stencil process and tools used would be helpful as I’m going to attempt two more with Archive X paints.


I hope you like it


This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top