Reply to thread

Back at it...

I secured all the external greebs via JB Kwik weld and machine screws (I don't want to bump into someone in a crowded area and have my whip cord box/hose/FThrower ripped off). I also installed the red LED for the gauntlet missile activator


RATTLE CAN COLORS First:     Rust-Oleum primer,

                             Second  Rust-Oleum METALLIC ALUMINUM,

0000 Steel wooled the gaunts, Then Testors Silver, then Testors Matte Black to wash out the sparkle.

Masked,

Then RATTLE CAN GLOSS MERLOT (No Claret Wine at Lowes or Home Depot___Claret replaced with Merlot??___)


Then Some dusting of crushed up charcoal with a paint brush.

Then another Testors black wash.


Very glossy! I'll use Rust-Oleum satin clear and then some Testors Dull coat once it dries.

[ATTACH=full]134284[/ATTACH][ATTACH=full]134285[/ATTACH][ATTACH=full]134286[/ATTACH][ATTACH=full]134287[/ATTACH][ATTACH=full]134288[/ATTACH][ATTACH=full]134289[/ATTACH][ATTACH=full]134290[/ATTACH][ATTACH=full]134291[/ATTACH][ATTACH=full]134292[/ATTACH][ATTACH=full]134293[/ATTACH]501 doesn't mention where damage should be... (I deduce, it's implicit that if it's not ridiculously excessive) Looking at ref pix... The weathering Damage is Laughable. I decided to make it look a little more "realistic". Once unmasked it'll make more sense. Corners were more important than just randoms silver blobs brushed on.


Also,

The New "Animals As Leaders" Is sick (Blasted it while airbrushing)


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top