Reply to thread

Message: <blockquote data-quote="Dha Syntir" data-source="post: 99463" data-attributes="member: 1282"><p>Yeah, Home Depot had both the brass and nickel hinges, I also went with the nickel hinge. I'm still deciding whether or not I want to fasten the hinges to the gauntlets with epoxy, pop rivets, or both. I'll probably err on the side of caution and do both so I never have to worry about it falling apart. Also, I've seen a few photo's of peoples gauntlets and it looks like some have trimmed out about an eighth of an inch about the size of the hinge on either side of the gauntlets to fit the hinge. Will I need to do that as well? I can only assume that's so the hinge moves unobstructed...</p></blockquote><p></p>

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification