Reply to thread

Hey guys, I'm making an ROTJ flamethrower master that's going to be molded to cast a hollow fiberglass copy. I know I'm limited in my knowledge of details on this piece. So I wanted to see of you guys could make some suggestions to improve it before molding. I'm planning to mold it in the two separate pieces as shown unless someone tells me I'm headed in the wrong direction.

Thanks,

Cruzer


[ATTACH]46780[/ATTACH]


[ATTACH]46781[/ATTACH]


[ATTACH]46782[/ATTACH]


[ATTACH]46783[/ATTACH]


[ATTACH]46784[/ATTACH]


[ATTACH]46785[/ATTACH]


[ATTACH]46786[/ATTACH]


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top