Reply to thread

Finished the weathering on my cod piece & back plate & went to work on the on attachment for the cod piece & back plate.  I made the studs decorative on the cod piece, but if for some reason in the future I want to make them functional that is an option.  The studs need a little bit of weathering & are the pieces that I had 3D printed.  They have an 8-32 nut epoxied into the back & are screwed the cod piece.   I made up a belt system to hold the back plate around my waist & the cod piece over laps the back plate & attaches with velcro.  I made the belt set up after putting on the girth belt & ammo belt the weight of these caused the back plate to slide down.  I didn't feel like this was very secure. This pulls the back plate tight against my back & is very secure & after the girth belt & ammo belt is put on it is hidden.  The girth belt also helps hold the cod piece secure.  Attached the "thong" strap to the back plate & the belt clasp with snaps.  Used a 1" wide piece of elastic, but needs to be weathered.


[ATTACH=full]42058[/ATTACH]


[ATTACH=full]42059[/ATTACH]


[ATTACH=full]42060[/ATTACH]


[ATTACH=full]42061[/ATTACH]


[ATTACH=full]42062[/ATTACH]


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top