Reply to thread

That's a really cool way to rig one up but I know for a fact that I don't have that much room in my bucket.


I was wondering if a set up like this would work, the top thing represents the servo arm on the stalk and the bottom is one connected to the servo its self with a bar to connect the two. Does anyone else think or know if this will or will not work?


[ATTACH=full]84780[/ATTACH]


Please forgive my microsoft painting skills...


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top