Reply to thread

Don't really know if the way I did ours will help but......

I put notches in the front edges of the servo extension.....made a pin to extend across it.....rotated the servo conterclockwise to vertical....put the stalk vertical....marked and cut

the stalk to match the pins...works fine.

[ATTACH]160985[/ATTACH]   [ATTACH]160986[/ATTACH]   [ATTACH]160987[/ATTACH]   [ATTACH]160988[/ATTACH]   [ATTACH]160989[/ATTACH]


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top