Reply to thread

You can wire a 2 channel relay switch to the servo that is activated with a key fob. Then, if you're handy with a soldering iron, desolder the switches from the fob then resolder them on 12" leads. Hold the leads i  place by taping them around around your middle and ring fingers under your gloves with the switches on your fingertips. Hide the rest of the fob under your gauntlet. I can then activate the servo without anyone noticing that i'm pressing the button on my finger with my thumb.


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top