Reply to thread

It actually had a really nice gap and shape from the start. It is an AnimeFan dentless helmet. I was concerned about it warping since I was told that could be a concern. I always kept it on a roll of paper towels as a stand and had zero issues. Hopefully it goes back Into shape for the weekend since I don't think I can get the DVH one ready that quick. Here is a pic from before with the visor just sitting on the helmet not attached.


[ATTACH=full]148512[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top