Reply to thread

Chin cup


For the chin cup, I found a factory that made a metal mold to mold a soft, flexible polypropylene chin cup. In a few weeks I had samples ready to arm a new batch of super soldiers.

[ATTACH=full]245137[/ATTACH]

[ATTACH=full]245138[/ATTACH]

[ATTACH=full]245139[/ATTACH]



A few weeks later, these chin cups were delivered to me.

[ATTACH=full]245140[/ATTACH]



Vintage Everoak & Replica Chin Cup.

[ATTACH=full]245141[/ATTACH]


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top