Reply to thread

The main arm tube piece looks ovoid/oval in the pictures. ... I suspect you've actually trimmed both those sides too much meaning that the gauntlets are now oval, not round as they probably are meant to be. If it was round the top cap would not have this issue. The sides would meet the tube correctly The easiest solution is break the joints on the tube again and put in a small fillet piece top and bottom in order to make the gauntlet tube circular again as its probably meant to be ....if you put the fillet at the back the fronts can be filled in with Bondo and sanded.


Apologies if this solution offends or is a duplicate of another.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top