Reply to thread

I used epoxy fiberglass to strengthen my styrene backplate.It worked like a charm,and it's rock solid.I had no problems with the heat warping the styrene,or any reaction from the epoxy.Hope this helps.


Steve


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top