Reply to thread

Eventually, the resin could attack and break-down the styrene, but most likely, the resin will be cured before that would happen.  Once the resin is cured, it becomes stable.  The reason resin attacks polystyrene is because the solvent in resin is styrene-monomer.  I hope this helps clear things up better for you. :)


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top