Reply to thread

for my helmets i usually do 4-5 8oz coats. it makes the helmet thin but consistent. like a vac formed plastic one.


i do get a full coat across the whole helmet... i've found the trick to not getting drips is to have very little resin in there... once you've coated the whole thing there shouldn't be anywhere thick enough really to drip.


it took me about 8 helmets to actually get them just the way i like.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top