Reply to thread

Thanks to all of you,  as you probably saved me a lot of time.


I know this project sounds dumb,  but I want to have something reproducable,  that I can sculpt on top of.  And more to the point,  machine into.  


Im also going to be throwing some 'old school' nods into the build,  which is going to start as a basic mando helmet,  and then if I can pull it off,  make something nice out of it.


Im in trial and error mode atm,  and your input is saving me a lot of error.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top