Reply to thread

If you look at the tutorial it tells you that when I built mine I opened and removed everything but the gears and motor from the inside of my servo.  After that you simply wire the board to the 2 connections on the motor itself.


Lemme know if you need further explanation.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top