Reply to thread

Ok got the servo and the RC board. It is not axactly the same but very similar. The servo had 3 wires coming out of it and the diagram only shows 2. I have not been able to get it to work. This is what I have:

4 wires on the RC board, Yellow,green, Red and White. 3 wires on the servo, yellow, Red, Black. Itried connecting the servo directly to the battery pack but still got nothing?


Anyone help!!!


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top