Reply to thread

Message

I'll almost surely be throwing it up for free on thingverse, just gotta tweak some things to make it easier to work with. Like namely getting the connection of the rings to the base layer just right so they can be snapped off easily so you don't have to individually cut em all off. Make it too thin though and the prints start to fail. Also gotta make the optional STL's for larger/smaller sheets and make a readme or video explaining it all. Pretty much just making it release quality versus personal printer quality ya kno.

[QUOTE="Grimstuff, post: 499234, member: 8643"] I'll almost surely be throwing it up for free on thingverse, just gotta tweak some things to make it easier to work with. Like namely getting the connection of the rings to the base layer just right so they can be snapped off easily so you don't have to individually cut em all off. Make it too thin though and the prints start to fail. Also gotta make the optional STL's for larger/smaller sheets and make a readme or video explaining it all. Pretty much just making it release quality versus personal printer quality ya kno. [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification