Reply to thread

Well, because before I didn't know how to use the Dremel :p . You're definetly right about it not being easy! I still have some work to do on the visor (if you notice they are uneven) and I almost screwed up the keyslots! You're right, that Dremel doesn't cut cut, it freaking melts the plastic. LOL

 

Hopefully I should be able to do some more work on it today.


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top