Reply to thread

Message

If I'm orientated right in my head I think that particular overhang is intentional, so as to be part of the front cheek area which overhangs to help maintain the circular curve.
You can see them in the image rafal posted above:

[ATTACH]102525[/ATTACH]

Maybe a slight bottom overhand on the sides are intentional too now that I look at it closely. I think you said those fit good on the bottom base though and the problem was on the dome part, so maybe not, dunno. Maybe Rafal could chime in.

But yeah, either way, except for those 3 intentional forward/bottom ones, you'll be fine shimmying all the others up to be flush. The curvature of the wrap will make them all moot anyway.

[QUOTE="Grimstuff, post: 352252, member: 8643"] If I'm orientated right in my head I think that particular overhang is intentional, so as to be part of the front cheek area which overhangs to help maintain the circular curve. You can see them in the image rafal posted above: [ATTACH=CONFIG]102525[/ATTACH] Maybe a slight bottom overhand on the sides are intentional too now that I look at it closely. I think you said those fit good on the bottom base though and the problem was on the dome part, so maybe not, dunno. Maybe Rafal could chime in. But yeah, either way, except for those 3 intentional forward/bottom ones, you'll be fine shimmying all the others up to be flush. The curvature of the wrap will make them all moot anyway. [/QUOTE]

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification