Reply to thread

I am running into the same problem. Coming up with the supplies. I will update as possible but in some areas gluing to make the 2mm will be definitely fine an needed (ie the way the ears are designed.) But a difficulty is (from experiance) is bending 2mm stock that's been glued together. So I'm toying around with using key parts and making it work (using card stock as the shell).  If you have any input or ideas please let me know as these are the absolute best plans I've found.




Sent from my iPhone


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top