Reply to thread

I'm new to this and have been researching for weeks so I can make the best helmet possible. Actually i'm going to make multiple helmets using different methods. Anyways I was wondering if I could use cardstock to make this helmet? Does it have to be the 2 mm thickness? And also if I make the 2 mm thick cardboard version, can I fiberglass resin the helmet, will it have the same effects as it does on cardstcok with pepakura?


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top