Reply to thread

If you have got the gold leaf on your helmet you will definitely need to sand it off and possibly re-primer your helmet, when using rub n buff the surface needs to be super smooth like glass smooth for the best results, so primer it, then sand with varying grades of wet and dry until it is super smooth, then apply the rub n buff, good luck :thumbsup:


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top